Emu XL-7 & MP-7 User's Group

T1 Trigger, Ch 01A
T2 Trigger, Ch 02A
T3 Trigger, Ch 03A
all are set to seq

with rechannelise always, i only get one arp (the one in the display) 
over all three triggers.

with on record, the arps sound right until i try and record them, 
after which i think (not at XL7 at moment) i get the one arp playing 
sporadically (sounds as if it gets cut off as the other triggers are 
played)

 
--- In xl7@yahoogroups.com, "steve_the_composer" <smw-mail@p...> 
wrote:
> A year ago or so, I got into using Trigger Notes (latched) to turn 
> arps on/off for developing a possible performance modality. I 
forgot 
> entirely what I did, but I do notice that the trigger notes setup 
> allows you to set the channel to Basic, C01A -> C16B (as well as to 
> various destinations). 
> 
> Over the past few days, I have been wanting to set up my E-Mu so I 
> can play tracks and triggers as arps, so I am ripe for testing your 
> setup.
> 
> What are your channel settings for the triggers?
> 
> Intuitively, I am thinking of comparing rechannelize always and 
> rechannelize on record to test your particular condition.
> 
> Have you tested both?  If so, any difference?
> 
> --Steve_the_diagnostician
> 
> 
> --- In xl7@yahoogroups.com, "joepm.rm" <joe@m...> wrote:
> > Just reviewing bits of the manual and appear to be stuck on pages 
> 26-8!
> > 
> > XL7, v2.0, using PX7 manual.
> > 
> > Setup the multichannel arps, tried to record the trigger buttons 
> > to "automate your multichannel arpeggiator performance".
> > 
> > followed the instructions, but it's not working.
> > 
> > Have set triggers to seq, tracks 1-3 are set to channels 1-3 and 
> > different arp presets.  with rechannelize on though, the triggers 
> > only use the track in the display.  with it off, things work 
until 
> i 
> > try to record, at which point it sounds fine but either nothing 
> gets 
> > recorded or only one of the tracks intermittantly (as if 
triggering 
> > the other tracks is cutting it off)
> > 
> > is there a known problem with this?
> > 
> > I've read in the tips and tricks:
> > To record into the internal sequencer, set the TRIGGERS 
destination 
> to
> > be "seq" instead of "int" or "ext" This way, the triggers will be
> > routed to the sequencer, which will then decide where to route it 
> > based on the track settings (provided you have rechannelize on).
> > 
> > but it does no good.