Yahoo Groups archive
Thread
2003-11-10 by stx303
I was working on something on my XL-7, and when i tired to save it said sve error code 100 and went into data comapcting mode, so i;ve lost all my saved stuff (not much), and when it ended the compacting process it still won;t let me save. so what does code 100 mean and or what's wrong with it?
2003-11-10 by erik_magrini@Baxter.com
Very strange, the compaction is completely normal and will happen every
now and then (read the FAQ for a detail description). Still, after the
process is over, you should still have all of your data there. You didn't
turn off the power in the middle of the compaction process did you? Maybe
try reintializing the unit (after you BACK EVERYTHING UP)?
rEalm
stx303 <stx303@...>
11/10/2003 10:49 AM
Please respond to xl7
To: xl7@yahoogroups.com
cc: Subject: [xl7] Save Error I was working on something on my XL-7, and when i tired to save it said sve error code 100 and went into data comapcting mode, so i;ve lost all my saved stuff (not much), and when it ended the compacting process it still won;t let me save. so what does code 100 mean and or what's wrong with it? To unsubscribe from this group, send an email to: xl7-unsubscribe@yahoogroups.com Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ [Non-text portions of this message have been removed]
2003-11-10 by pgicedrop
I had the same problem a while ago. I had an error when saving, my xl- 7 went on compacting mode and had not a single pattern anymore when it came back to life. I assumed that this occured because I had installed all the patterns from the protean drums and the pop ROMs on top of the xl7 patterns and had only 10% or so of memory available. Patrick --- In xl7@yahoogroups.com, "stx303" <stx303@y...> wrote: > I was working on something on my XL-7, and when i tired to save > it said sve error code 100 and went into data comapcting mode, so
> i;ve lost all my saved stuff (not much), and when it ended the > compacting process it still won;t let me save. so what does > code 100 mean and or what's wrong with it?