MOTM

Hello, and welcome!

This was probably a typo, but you don't really mean that you're using a
+/-5v power supply, correct...?

-----Original Message-----
From: motm@yahoogroups.com [mailto:motm@yahoogroups.com] On Behalf Of
michaeldavidstein
Sent: Friday, May 26, 2006 12:11 PM
To: motm@yahoogroups.com
Subject: [motm] .com to MOTM adapter problem? & newbie introduction

Hello,
I am new to the group this is my first post. The problem is that my 
MOTM 440vcf is hardly audible when the resonance knob is not at or 
above 7, and at this setting theres not much versatility for a wide 
variety of sounds. I am using a .com power supply +/-5V with the single 
adapter from .com. It is not the module because I sent it back to paul 
s. and he checked it out and everything was in good working order for 
him. So I just put in an order for the MOTM-995 adapter board. I hope 
this is the problem and my adapter is bad. Has anyone ever had a 
problem with the .com to motm adapter from .com? Any suggestions on 
what else could the problem be? the rest of my modules function great 
but they are all .com and i believe my power supply is good. Also, 
anyone selling any MOTM filters, LFO's, or the MOTM-120.
thanks,
-michael-

All .com powersupplies are +/-15v and +5v, even the NOS, if I'm not 
mistaken.

I can't answer the question about the .com adapter, but the 995 power 
distribution board works great and makes sense:  you plug in *ONE* 
power cable from your .com powersupply and you can power six MOTM 
modules.  I'm currently powering a 440, 510, 390, and Blacet TM with 
no problems (as well as a host of .com modules).

Michael:  did you try swapping out the power cable connected to the 
adapter?

Hans



--- In motm@yahoogroups.com, "Tkacs, Ken" <ken.tkacs@...> wrote:
>
> 
> Hello, and welcome!
> 
> This was probably a typo, but you don't really mean that you're 
using a
> +/-5v power supply, correct...?
> 
> 
> -----Original Message-----
> From: motm@yahoogroups.com [mailto:motm@yahoogroups.com] On Behalf 
Of
> michaeldavidstein
> Sent: Friday, May 26, 2006 12:11 PM
> To: motm@yahoogroups.com
> Subject: [motm] .com to MOTM adapter problem? & newbie introduction
> 
> Hello,
> I am new to the group this is my first post. The problem is that my 
> MOTM 440vcf is hardly audible when the resonance knob is not at or 
> above 7, and at this setting theres not much versatility for a wide 
> variety of sounds. I am using a .com power supply +/-5V with the 
single 
> adapter from .com. It is not the module because I sent it back to 
paul 
> s. and he checked it out and everything was in good working order 
for 
> him. So I just put in an order for the MOTM-995 adapter board. I 
hope 
> this is the problem and my adapter is bad. Has anyone ever had a 
> problem with the .com to motm adapter from .com? Any suggestions on 
> what else could the problem be? the rest of my modules function 
great 

> but they are all .com and i believe my power supply is good. Also, 
> anyone selling any MOTM filters, LFO's, or the MOTM-120.
> thanks,
> -michael-
>