MOTM

All .com powersupplies are +/-15v and +5v, even the NOS, if I'm not 
mistaken.

I can't answer the question about the .com adapter, but the 995 power 
distribution board works great and makes sense:  you plug in *ONE* 
power cable from your .com powersupply and you can power six MOTM 
modules.  I'm currently powering a 440, 510, 390, and Blacet TM with 
no problems (as well as a host of .com modules).

Michael:  did you try swapping out the power cable connected to the 
adapter?

Hans



--- In motm@yahoogroups.com, "Tkacs, Ken" <ken.tkacs@...> wrote:
>
> 
> Hello, and welcome!
> 
> This was probably a typo, but you don't really mean that you're 
using a
> +/-5v power supply, correct...?
> 
> 
> -----Original Message-----
> From: motm@yahoogroups.com [mailto:motm@yahoogroups.com] On Behalf 
Of
> michaeldavidstein
> Sent: Friday, May 26, 2006 12:11 PM
> To: motm@yahoogroups.com
> Subject: [motm] .com to MOTM adapter problem? & newbie introduction
> 
> Hello,
> I am new to the group this is my first post. The problem is that my 
> MOTM 440vcf is hardly audible when the resonance knob is not at or 
> above 7, and at this setting theres not much versatility for a wide 
> variety of sounds. I am using a .com power supply +/-5V with the 
single 
> adapter from .com. It is not the module because I sent it back to 
paul 
> s. and he checked it out and everything was in good working order 
for 
> him. So I just put in an order for the MOTM-995 adapter board. I 
hope 
> this is the problem and my adapter is bad. Has anyone ever had a 
> problem with the .com to motm adapter from .com? Any suggestions on 
> what else could the problem be? the rest of my modules function 
great 
> but they are all .com and i believe my power supply is good. Also, 
> anyone selling any MOTM filters, LFO's, or the MOTM-120.
> thanks,
> -michael-
>