Re: [korg_mono-poly] Mono/Poly problems
2009-01-04 by Florian Anwander
Hello rperalta78 ... I think: If you are not familiar with electronics basically, then you definitely should keep your hands of power supplies. Each mistake
Messages
Browse messages
Page 14 of 19 · 939 messages matched
Mono/Poly problems
2009-01-04 by rperalta78
when i turned on my korg MP4 last week i noticed that there was a little smoke coming out of what appears to be the power supply(its says on top 250v fuse)and
FIXED! Re: new member - suddenly silent / hissy MP4....
2008-12-22 by simezagreb
Hi Florian Happy to report that my new SSM2044 arrived from vintage planet in the Netherlands in record time. Popped it in and all is well. The synth sounds
Re: new member - suddenly silent / hissy MP4....
2008-12-14 by simezagreb
Hi Florian I might of lost something in translation here. This is what I measuring... I am referenceing the 2044 datasheet here:
Re: [korg_mono-poly] Re: new member - suddenly silent / hissy MP4....
2008-12-10 by Florian Anwander
Hi Simon ... I mean difference between each of them and ground. Florian
Re: new member - suddenly silent / hissy MP4....
2008-12-10 by simezagreb
Hi Again ... pin ... Hummm.. do you mean the voltage difference between those two pins? Or the difference between each of them and ground?? thanks and thanks
Re: [korg_mono-poly] Re: new member - suddenly silent / hissy MP4....
2008-12-09 by Florian Anwander
Hi Simon ... Now, still there is a little hope for the 2044. Check the voltage at pin 15 (offset) and pin 13. If it would be -15 Volts, then the VCF would shut
Re: new member - suddenly silent / hissy MP4....
2008-12-09 by simezagreb
Hi Florian, Thanks man! I m enjoying this, nerd that I am. Indeed can t get the filter to self oscillate audibly as per your instructions. There is signal
Re: [korg_mono-poly] new member - suddenly silent / hissy MP4....
2008-12-08 by Florian Anwander
Hi Simon ... if you turn all four parameters of the VCA-Envelope fully counter-clockwise. Playing a key you should hear a klick. - if yes - VCA is good and
new member - suddenly silent / hissy MP4....
2008-12-08 by simezagreb
Hi All Long time MP4 lover here.. turned it on today after a couple of months storage and it s virtually silent, till I crank the headphones loud and then....
Re: TR606 and Mono/Poly
2008-11-08 by homemcouve
Thanks for the info Florian! ... triggering of ... some
Re: [korg_mono-poly] TR606 and Mono/Poly
2008-11-08 by Florian Anwander
Hi Louis ... Trigger-out606 to Arpeggiatorclock-in-MP will cause a late triggering of the Arpeggiator. The Arpeggiator is a switched trigger in. You need some
Re: TR606 and Mono/Poly
2008-11-08 by homemcouve
More info: The TR-606 Rhythm Composer provides two independant, programmable TRIGGER OUTs to allow interfacing with synthesizers or sequencers. Each trigger is
Re: TR606 and Mono/Poly
2008-11-08 by homemcouve
The specifications are: TRIGGER OUT x 2 Mini-jack (HT, LT; +14V. 20 mSec pulse)
Re: TR606 and Mono/Poly
2008-11-08 by homemcouve
Hi, the TR606 has 2 trigger out minijacks. One associated with the Low Tom and the other to the High Tom. I tried connecting but I must have done something
Re: [korg_mono-poly] TR606 and Mono/Poly
2008-11-08 by Nick Fletcher
The Mono/Poly can send and respond to trigger signals and voltage signals for the specification of pitch. As long as the voltages between both units are
TR606 and Mono/Poly
2008-11-08 by homemcouve
Hi everyone, can anyone tell me how to sync the tempo of the MonoPoly arpeggiator to the TR606? Thanks Luis
Re: keys not working
2008-10-13 by oli_larkin
thanks for the link oli ... them or a fine film has built up. Check out this page ... identical to the monopoly all save the extra octave.
Re: [korg_mono-poly] mono/poly power supply
2008-10-10 by Jose Suarez
Thank you Florian, our help was amazing ... De: Florian Anwander Asunto: Re: [korg_mono-poly] mono/poly power supply Para:
Re: [korg_mono-poly] mono/poly power supply
2008-10-10 by Florian Anwander
Hello The transformer delivers 2 x 22,0 Volts AC After measuring at the two big capacitors I find 25.0 Volts DC at the large cap, and 26.6 Volts DC at the
mono/poly power supply
2008-10-10 by pepesinte
Hi everybody: I need some info about the psu of the mono/poly. Sadly thhe old one has died I need to know how many volts arrive to the board from the power
Re: [korg_mono-poly] keys not working
2008-10-09 by Alan Dicker
Yeah sounds like the rubber contacts may have a either dirt under them or a fine film has built up. Check out this page
keys not working
2008-10-09 by oli_larkin
I just noticed that the top 3/4 keys on my monopoly have stopped working properly. Sometimes there is a latency when i press them and sometimes a note doesn t
RE: [korg_mono-poly] Re: Problems tuning the monopoly
2008-09-08 by alexander.henriksson@seb.se
Hi there Danjel! I had the same problem as you with the tuning of OSC 3. But while trying to tune it i burnt the whole PSU. I wonder, when i have repaired it:
VCOFM in = not in tune?
2008-09-07 by intellijel
My monopoly is all tuned up now if I play it by keyboard or external CV. However, when I use the VCOFM in trick so I can trigger chords it seems like it screws
Re: Problems tuning the monopoly
2008-09-07 by intellijel
So I finally figured out the stretch tuning system. I have to say that the manual was terrible in explaining what needed to be done and it was only from
Re: Problems tuning the monopoly
2008-09-07 by intellijel
So to update: I can now see the holes in the pcb where I can reach the VR101, VR201 etc. (The lighting in my room is not so great). However I still totally
Problems tuning the monopoly
2008-09-07 by intellijel
Hi Guys, I went through the tuning section of the callbration procedure for the monopoly but ran into some issues. Everything went as expected (e.g. read and
Korg Mono/Poly + moog cp251
2008-09-07 by sigurvald1
Hi, Has anyone tried the cp251 with the monopoly?
Re: MIDI CV CONVERTERS
2008-08-21 by intellijel
I would like to redact my previous statement about the midi2cv8. I have been having problems with the gate level being suitable for reliably triggering notes
Re: [korg_mono-poly] cv+gate in is dropping notes
2008-08-21 by Florian Anwander
Hi Danjiel ... I use a HARMS Mac16 (very rare interface built in the late nineties by a german engineer in Hamburg, comparable to the kenton pro 2000 or
Re: [korg_mono-poly] cv+gate in is dropping notes
2008-08-21 by Danjel van Tijn
Hey Florian, Thanks for the info! (as usual :) ) So just to clarify, the trig input of the monopoly is a normal gate signal but the arp trig is an s-trig? I
Re: [korg_mono-poly] cv+gate in is dropping notes
2008-08-20 by Florian Anwander
Hi Danjel. What is exactly the source of the gate-signal? The monopoly expects (and sends) +15 Volts as gate. And the real threshold is set by R63/R62 at
cv+gate in is dropping notes
2008-08-19 by intellijel
When I sequence the monopoly from an external sequencer via the CV+trig in the sequence is totally in consistent. I get dropped/skipped notes frequently and
Re: [korg_mono-poly] MIDI CV CONVERTERS
2008-08-12 by Chase Smith
I have one to use with my mono/poly. It works well. The arp clock in is s-trig so your cable might have to be s-trig, although I think that there are s-trig
Re: MIDI CV CONVERTERS
2008-08-12 by intellijel
I use the paia midi2cv8 converter with my monopoly. I use the gate outs to trigger the arpegiator but I had to make a special cable to convert gate to
MIDI CV CONVERTERS
2008-08-12 by mammaltown
Does anyone have any experience using the Paia Midi CV converter with the mono/poly? I am wanting to get one, but am curious to know how it works with the
Re: [korg_mono-poly] problem with main output
2008-08-10 by Florian Anwander
Hi, I assume, the ground connection of the socket is dead. Florian
problem with main output
2008-08-10 by intellijel
It looks like the main output on my monopoly just died. I get an extremely quiet signal out of it now but the headphone out works fine. I looked at the
Re: [korg_mono-poly] Price of a Korg monopoly
2008-07-31 by Alan Dicker
650 isn t unreasnable but it is at the high end of most monopoly prices. I picked mine up for around £400 which is 507.54 Euros. Is worth every penny and
Price of a Korg monopoly
2008-07-31 by theprodigy11
I have been offered a Korg Monopoly for 650 Euros.. I really like the synth but I want to know is this a reasonable price for it. Thanks
Re: [korg_mono-poly] Need to buy replacement key
2008-07-22 by Florian Anwander
Hi Danjiel http://stores.ebay.nl/organparts is your friend. Florian (lurking around at the same places as you...) ... -- Florian Anwander
Need to buy replacement key
2008-07-22 by intellijel
Just got a mono/poly and am I amazed by the organic and liquid sounds I get out of it. This synth is way more interesting to me than a Minimoog or Jupiter or
Re: [korg_mono-poly] problem with "Effects On/Off"-button
2008-07-11 by Florian Anwander
Hi As the others I assume the switch is faulty. You may test it by shorting the switch-contacts. You can do this either direct at the switch pcb, or by
Re: [korg_mono-poly] problem with "Effects On/Off"-button
2008-07-10 by Alan Dicker
the trick it to get the switch cleaner and or alcohol in to the switch its self and not just spray over it. To do this you will need to open up the monpoly
Re: [korg_mono-poly] problem with "Effects On/Off"-button
2008-07-10 by Brinkmann Music
Mine still lights, but is difficult to turn on and off- takes several tries. I sprayed contact cleaner on the switch, but it still acts up. It s the only
problem with "Effects On/Off"-button
2008-07-10 by lang_hat
Hey MP4-users. Suddenly the Effects on/off , on my MP4, has stopped working. The LED doesn t light and the effects are not being activated. Its pretty
Re: Missing buttons on my just acquired Mono/Poly
2008-06-05 by goguipics
Dear Florian, thank you very much.I´ll look at all the links you have posted. Thank you! José
Re: [korg_mono-poly] Missing buttons on my just acquired Mono/Poly
2008-06-05 by Florian Anwander
Uuups ... it is www.vintageplanet.nl of course. Senso from Vintageplanet is a very nice and helpful guy from the Netherlands. Johann Henry (aka organparts) is
Re: [korg_mono-poly] Missing buttons on my just acquired Mono/Poly
2008-06-05 by Florian Anwander
Hi its always worth checking Senso at www.vintageplante.nl or http://stores.ebay.es/organparts (on the second page of his shop there are the knobs of the