Yahoo Groups archive
Thread
2009-06-15 by vaillant franck
Hi the group! Is it possible that the BEND parameter could be either positive or negative to get a descending or ascending sound ....( like on the SDS7 ) For the moment it's fixed to the descending sound ... Michael can you help ...? [Non-text portions of this message have been removed]
2009-06-15 by jesper
vaillant franck skrev: > Hi the group! > Is it possible that the BEND parameter could be either positive or > negative to get a descending or ascending sound ....( like on the SDS7 ) > For the moment it's fixed to the descending sound ... > Michael can you help ...? Yes. You should be able to get it to do either or. -- electronically yours, jesper - -- --- ---- ----- ---- --- -- - www.electronic-obsession.se www.myspace.com/machinepop
2009-06-15 by Michael Buchner
It is possible. On the Cymbal and Hihats there is an inverter circuit for this purpose, this has to be added. In fact this is only one IC, but it has to be soldered somewhere on the board. Zero (no bend) will be in the center of the control knob then. Regards Michael
----- Original Message ----- From: vaillant franck To: Simmons_Drums@yahoogroups.com Sent: Monday, June 15, 2009 5:17 PM Subject: [Simmons Drums] ABOUT THE SDSV ... Hi the group! Is it possible that the BEND parameter could be either positive or negative to get a descending or ascending sound ....( like on the SDS7 ) For the moment it's fixed to the descending sound ... Michael can you help ...? [Non-text portions of this message have been removed] [Non-text portions of this message have been removed]
2009-06-15 by Berk Aarts
hai sde expander http://link.marktplaats.nl/258446841 & SDS V http://link.marktplaats.nl/239178026 greets Berk
2009-06-15 by superwolle70
I just have a unit hooked up where you cannot adjust "bend up" in any module. So possibly there are several generations --- In Simmons_Drums@yahoogroups.com, "Michael Buchner" <buchnerelectronics@...> wrote:
> > It is possible. On the Cymbal and Hihats there is an inverter circuit for this purpose, this has to be added. In fact this is only one IC, but it has to be soldered somewhere on the board. Zero (no bend) will be in the center of the control knob then. > Regards > Michael > ----- Original Message ----- > From: vaillant franck > To: Simmons_Drums@yahoogroups.com > Sent: Monday, June 15, 2009 5:17 PM > Subject: [Simmons Drums] ABOUT THE SDSV ... > > > > > > Hi the group! > Is it possible that the BEND parameter could be either positive or > negative to get a descending or ascending sound ....( like on the SDS7 ) > For the moment it's fixed to the descending sound ... > Michael can you help ...? > > [Non-text portions of this message have been removed] > > > > > > [Non-text portions of this message have been removed] >