I have a couple of questions about tolerances on FracRack panels I want to send to Schafer.
1. What tolerance is typically specified for width, holes, etc.?
2. How much smaller should I make the board to allow assembly?
I saw some specs. on a FracRack panel:
Deburr outside edges, do not round corners
Light grain, black anodize
tolerances: +/- 0.010 in
Holes +/- 0.005 in
Are these reasonable?
Should I just design the panel to be 0.010 inches smaller in width?
Thanks
David
David M. Ingebretsen M.S., M.E.
Collision Forensics & Engineering, Inc.
2469 East Fort Union Blvd. STE 114
Salt Lake City, UT 84121
www.CFandE.com
801 733-5458 Office
801 842-5451 Cell
dingebre@...
dingebre@...