----- Original Message -----From: Scott JuskiwSent: Thursday, July 03, 2008 8:49 PMSubject: [ModularSynthPanels] Panel for JH String FilterI just got my boards for the JH String Filter and I'm seriously
tempted to turn this into a 40 channel filter bank (using pots, not
sliders). I've drawn up a few MOTM-format panel layouts on paper and
will try to upload some images this weekend. We're talking 40 pots
here, just for the filters, plus:
4 pots (input level, Q level, Q CV level, stereo spread)
4 switches (partials 1,2,3,4)
4 jacks (signal input, Q CV input, left out, right out)
Did I miss anything?
I suppose you could leave out the 4 partial switches since each filter
has it's own dedicated level pot, but I'd still like to keep them in.
I've got three layouts at the moment:
1. 10U wide using standard (large) MOTM knobs
2. 5U wide using small knobs (like on Encore UEG)
3. 6U wide using small knobs for the 40 filters and large knobs for
the other 4 pots
I'll build a prototype (using plastic) for either #2 or #3 to make
sure it all works properly first.
Is anyone else interested in pursuing this?
Has somebody else already started working on an MOTM-format panel for
this?
Message
Re: [ModularSynthPanels] Panel for JH String Filter
2008-07-03 by krisp
Ok I going to put my hand up and say I daft enough
to try this
the 5U sounds good keep it all looking similar on
the panel 10U would be 2 big
Have you started on the SM caps 30 per board I
finished off my 3 set's 180 sm caps
I needed a beer after that I can tell
you
I think there's a 2U one on Bill and Will's site
cheers
Paul Darlow