| previous by date | index | next by date |
| previous in topic | topic list | next in topic |
Wow, tough call! If I were doing it for myself, I would doone of two things. If I went with the horizontal version I’d go off thestandard MOTM grid and move filter A’s jacks up into the section with thecontrols and move section B down a bit etc. But if I really was going to buildthis I would do the vertical design but in 2U instead of 3U by combining theFrequency and Frequency CV controls into a dual concentric pot (if possible),moving the Mode switches down to where the Frequency CV controls were and thenmove the Input jacks up and the Output jacks over underneath the Input jacks.
John L Rice
From:ModularSynthPanels@yahoogroups.com [mailto:ModularSynthPanels@yahoogroups.com]
Sent: Saturday, August 22, 2009 1:16 PM
To: ModularSynthPanels@yahoogroups.com
Subject: [ModularSynthPanels] New poll for ModularSynthPanels
Enter your vote today! A new poll has been created for the
ModularSynthPanels group:
For an MOTM-format CGS Dual CMOS Filter, do you prefer the vertical orhorizontal layout?
They're in the Proposed Bridechamber Designs folder.
o Vertical
o Horizontal
To vote, please visit the following web page:
http://groups.yahoo.com/group/ModularSynthPanels/surveys?id=2220793
Note: Please do not reply to this message. Poll votes are
not collected via email. To vote, you must go to the Yahoo! Groups
web site listed above.
Thanks!