Hi again
�
Im guessing that if you are getting the same results, it really is not possible. I just printed out the BTS section from the manual and Im back in front of the 2500 in about 1 hour and have a few little hunches (but nothing that I have not probably tried already)..
�
Up to now I have only used the BTS riffs externally from Ableton Live and they work fine. It took me a few days to realise that there is only 1 BTS part allowed out of the 16 multi timbral parts – this does not seem to be particularly clear from the manual but once you know this, it is fine. Moreover, the BTS part has to be setup in the multi setup (I think I always have it as part 1 but don’t recall).
�
Anyway, more testing later..
�
Thanks again,
�
Paul
London
www.punkdisco.co.uk
�
From: xl7@yahoogroups.com [mailto:xl7@yahoogroups.com]
Sent: 30 October 2016 12:31
To: xl7@yahoogroups.com
Subject: Re: [xl7] Re: BTS - Triggering from the Sequencer (Beats Mode)
�
�;
Friday I played around with triggering BTS from the audition button and then recording some notes, busy beats, and vari beats. Yesterday I played around trying to insert events into the sequencer manually (plus pan changes from my usb keyboard so I can see and hear my connection). Also, I tried recording the C-2 Start/Stop Beats Trigger, latched along with C-1 as Parts 1, latched).� Today, I am going to systematically try a few ways to get the sequencer to turn the BTS sequencer on and off (writing down my settings and changes as I go).� The sequence from yesterday doesn't seem to be turning on the BTS sequencer, though it is playing the data I recorded--basically what you discovered.
If I cannot get the BTS sequencer to start/stop from within the sequence, I will see if I can do it using an embedded sysex command--first by issuing an audition command.
Maybe I can figure this out.
Attachments
- No local attachments were found for this message.