Emu XL-7 & MP-7 User's Group

From my experience with a virus (TI if that matters), this works with one caveat - the patch on the global MIDI channel is changed too. My workaround was to use channel 16 as the global, since my multis never use up all 16 channels. Hope this helps.

--- In xl7@yahoogroups.com, Nathan Steele <XTCaine303@...> wrote:
>
> 
> 
> Not sure which virus you are using but page 120 of the virus c manual 
> states:
> 
> "MULTI PROGRAM CHANGE ENABLE
> This function controls if the VIRUS receives pro-
> gram changes of multi-setups. If enabled, the
> VIRUS switches an entire multi-setup by a pro-
> gram change. The global MIDI channel has to
> be used to receive the program change. Please
> note that the multi program change will no
> work in the single-multi mode, because, in this
> mode, the display is unable to show the
> change."
> 
> This is a system parameter setting. I don't own a viruse so I may not be 
> able to help much further.
> 
> your best bet if you want to use the same multi for a whole pattern in 
> the command station is to put the program change in the Tick 0. I have 
> tried to figure this out myself and followed instructions but couldn't 
> get it to work, can someone who did this and had it work please explain it?
> 
> 
> 
> On 6/10/2013 4:30 PM, nikitsanpsix wrote:
> >
> >
> >
> > --- In xl7@yahoogroups.com <mailto:xl7%40yahoogroups.com>, Susan 
> > Subtract <ryan.taylor.jorgensen@> wrote:
> > >
> > > program change message sent from command station?
> > >
> >
> > Yes! but how record it for change multisetup? Im using several 
> > channels (presets/tembres).
> >
> >
>