Emu XL-7 & MP-7 User's Group

Hmmmmm. If the "module switching" [not sure what that is] only happens when you press play, not when you dial up a new pattern, then I don't think the source of the problem is the pre-roll sysex data that gets sent.

Out of curiosity, what "modules" does the eiii switch out of and what mode does it switch into?

Steve

--- In xl7@yahoogroups.com, "dutchbeats" <dutchbeats@...> wrote:
>
> hey all, i just hooked up an e-mu eiiix sampler to my xl-7 and for some reason whenever i press play on the command station, the eiiix jumps out of whatever module is selected! as luck would have it, the part of the manual online for the eiiix for what i need for change this was left out so i had to use the same section from the original eiii manual. 
> 
> however, in the eiii manual there is the option of turning on and off external sequencer start/stop commands but this option is not available on the eiiix : ( i looked every where on the command station to see if i can turn off sequencer start/stop send commands but maybe i am missing something? i'll have to also ask on gearslutz or something if there is any way to change this within eiiix but alas.....
> 
> i might have to just get used to starting the sequencer twice quickly when moving in and out of editing modules in the eiiix, although i think most of the editing will be done with the sequencer stopped anyway. i have come to realize every sampler has a fatal flaw and in comparison to other samplers i've tried it's not that bad
>