I have a couple of outboard efx processors that I like to use... so for instance, if I want to route my snares and cymbals to one of my out-board reverb processors through submix 1... I select those tracks (which are on their corresponding midi channels) and route them to send 2. I get the dry audio from those tracks/channels at submix 1, but the dry audio also shows up at the main-output as well. I understand that if I turn the send amout for send 2 past 0, that I should be hearing the wet audio at the mains, and the dry on the sub... but if it is set to 0, then I should only get the dry on the sub, and nothing at the main....but no matter what I do, I can't get it out of the main. And whenever I switch efx modes, (to apply efx to only 1 preset) the efx saved in whatever preset is assigned to the selected channel applies it's efx settings to every preset on every channel. Confusing, huh? Andrew > To: xl7@yahoogroups.com > From: tttsystems@... > Date: Thu, 2 Oct 2008 17:43:46 -0400 > Subject: Re: [xl7] What am I doing wrong with the efx? > > All those words hurt my head...I'm going to have to read this a few times over to see where you are.... > > Bob > El Segundo, CA > > > -----Original Message----- > >From: Andrew <Alan_mansfield@...> > >Sent: Oct 2, 2008 4:52 PM > >To: xl7@yahoogroups.com > >Subject: [xl7] What am I doing wrong with the efx? > > > > > >It's my understanding that the effects on the XL-7 can either be used on only 1 preset, using the effects setting stored in that preset... or set up to run the same effects setting on every midi channel, using the 4 sends to control the amount of effect applied to each send, as well as selecting which output that send is routed to... or bypassed all together. When I bypass the effects, as expected, there are no effects... cool. However when I try to only run effects on one preset, I end up hearing that presets stored effects setting on every channels preset... and whenever I set it up to apply its effects to all presets through the sends, it works pretty much the way I think it should, except that whatever I set to sends 2 and 3 (sub mix 1 and 2) also shows up at the main output, even with those send levels all set to 0. I guess what I'm trying to accomplish is, if I set it up to only run its effects on one preset, that the effects only appear on that preset, and not on all of them... or if I set it up to apply its effects to everything through the sends, that whatever I route to sends 2 and 3 will only out-put the dry audio at the 2 sub-mixes if I set their send levels to 0. Any ideas? > > > >Andrew > > > >_________________________________________________________________ > >Stay up to date on your PC, the Web, and your mobile phone with Windows Live. > >http://clk.atdmt.com/MRT/go/msnnkwxp1020093185mrt/direct/01/ > > > >[Non-text portions of this message have been removed] > > > > > ------------------------------------ > > Yahoo! Groups Links > > > _________________________________________________________________ Stay up to date on your PC, the Web, and your mobile phone with Windows Live. http://clk.atdmt.com/MRT/go/msnnkwxp1020093185mrt/direct/01/ [Non-text portions of this message have been removed]
Message
RE: [xl7] What am I doing wrong with the efx?
2008-10-02 by Andrew