Emu XL-7 & MP-7 User's Group

I don't know about the midi implementation of the Micron. The manual 
doesn't say much.
You might have to do some research on that, to find out what CCs it will 
respond to.
Or, you could figure it out by trial and error. Try asking on the Micron 
mailing list.
For general information about midi try here:
http://www.borg.com/~jglatt/tutr/miditutr.htm

Dacian Victor wrote:

> ok.. i see, i set them in this mode
> is transmiting some CC(but just 0, 10, 11 ... the rest seem empty??),
> also is transmiting only for one channel, the channel on which the 
> notes are playing ..
> do you know from where i can get a complete list of the CC?
> thank's.. hope to succed//:)
>
>
> Greg Waltzer <egwaltzer@... <mailto:egwaltzer%40comcast.net>> 
> wrote:
> You don't need to use the realtime controllers A, B etc. Those are for
> use within the XL7 patches.
> >From the "controllers" menu, go to programmable knobs.
> Set the "CTRL" field to be the midi CC you want to transmit.
> Set the "Ch" to be the channel that the micron is receiving on.
> And on the right side of the display, set to "ext" or "both".
> Do the above for each knob you want to transmit.
>
> Dacian Victor wrote:
>
> >
> >
> > Thank's Greg, for the very quick answer.
> > Yes the knobs output midi is turned on, and also the midi change is on.
> > Did you succed to transmit knob messges?
> > I'm not sure for what or how i use "Ctrl:??" from Controller>>
> > Programmable knobs >>
> > and for what or how i use Realtime Controller A: .. B: ..
> >
> > My micron said: "Receive failed. Please try again."
> > But the notes are playing!!!
> >
> > What should i do???
> > thank's again
> >
> >
> >
>
> ---------------------------------
> Never miss a thing. Make Yahoo your homepage.
>
> [Non-text portions of this message have been removed]
>
>