Sequential circuits samplers

You're right, the other wires go to I-324 on the main PCB 
underneath the daughterboard. I'll try and borrow a better 
camera next week (Tuesday) to get some close-ups, but I 
should be able to send you the connection details tomorrow.

I can't see any evidence of cut traces, but I don't know 
what's underneath the board.

Cheers,

John :^P

plus_321 wrote:
> Thank you very much for that.  From what I can tell, and your short
> description, I bend up pin 11 on the CEMs and solder the 8 wires from
> one pcb directly to the pin.  However, there are 5 more wires on the
> board and it is very hard to see where they go in the pictures.  You
> probably could not take a photo of them without lifting the board off
> and I wouldn't ask you to do that (It is probably on there with
> two-sided tape).  
> 
> However, I have read a post in the archives awhile ago (I can't seem
> to find it now) where someone said that they had to cut traces to
> install the upgrade.  I think it was "ferrograph" who said it.  If so,
> do you remember what traces to cut, etc?
> 
> I am out of town now, but when I return tomorrow I will examine the
> photos again to see if I can figure out where the additional five
> wires go.
> 
> Again, thank you very much.


-- 
John Pallister
john@...