Sequential circuits samplers

Thank you very much for that.  From what I can tell, and your short
description, I bend up pin 11 on the CEMs and solder the 8 wires from
one pcb directly to the pin.  However, there are 5 more wires on the
board and it is very hard to see where they go in the pictures.  You
probably could not take a photo of them without lifting the board off
and I wouldn't ask you to do that (It is probably on there with
two-sided tape).  

However, I have read a post in the archives awhile ago (I can't seem
to find it now) where someone said that they had to cut traces to
install the upgrade.  I think it was "ferrograph" who said it.  If so,
do you remember what traces to cut, etc?

I am out of town now, but when I return tomorrow I will examine the
photos again to see if I can figure out where the additional five
wires go.

Again, thank you very much.