Sequential circuits samplers

Sorry to reply to my own post, but I've updated my page with 
details on the remaining connections. I have also checked 
underneath the voice board and there is no evidence of any 
cut traces that I can find.

Cheers,

John :^P

John Pallister wrote:
> You're right, the other wires go to I-324 on the main PCB 
> underneath the daughterboard. I'll try and borrow a better 
> camera next week (Tuesday) to get some close-ups, but I 
> should be able to send you the connection details tomorrow.
> 
> I can't see any evidence of cut traces, but I don't know 
> what's underneath the board.
> 
> Cheers,
> 
> John :^P
> 
> plus_321 wrote:
>> Thank you very much for that.  From what I can tell, and your short
>> description, I bend up pin 11 on the CEMs and solder the 8 wires from
>> one pcb directly to the pin.  However, there are 5 more wires on the
>> board and it is very hard to see where they go in the pictures.  You
>> probably could not take a photo of them without lifting the board off
>> and I wouldn't ask you to do that (It is probably on there with
>> two-sided tape).  
>>
>> However, I have read a post in the archives awhile ago (I can't seem
>> to find it now) where someone said that they had to cut traces to
>> install the upgrade.  I think it was "ferrograph" who said it.  If so,
>> do you remember what traces to cut, etc?
>>
>> I am out of town now, but when I return tomorrow I will examine the
>> photos again to see if I can figure out where the additional five
>> wires go.
>>
>> Again, thank you very much.
> 
> 

-- 
John Pallister
john@...