Discussion about the Korg PolySix synthesizer group photo

Yahoo Groups archive

Discussion about the Korg PolySix synthesizer

Index last updated: 2026-04-28 23:40 UTC

Message

Re: [PolySix] EG Intensity knob not working

2014-09-28 by robertfantinatto@rogers.com

Hi Johannes,

Thank you for the suggestion...

I checked the voltage on pin 1 of IC7 on the KLM-367 and it reacts as expected! About -5V CCW, 0 at indent, about +5 CW, I tried re-seating the CN05 cable on both ends, but that didn't work. I've checked that the signal is making it to pin 10 on the CN05 connector on the KLM-367 side and it is there as expected.

Any suggestions where I should look on the KLM-366?

Thanks so much!


Rob

Attachments

  • No local attachments were found for this message.

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.