Message
Re: [PolySix] EG Intensity knob not working
2014-09-28 by robertfantinatto@rogers.com
Well, I managed to repair the problem! Thank you so much for your help.
I found some corrosion on the KLM-366 board which prevented the signal from pin 10 to get to IC 15 pin 2, so I simply soldered in a wire to bridge this connection and it is now working beautifully!
Thanks again for pointing me in the right direction!
I've tried uploading a photo of the repair, but no luck, could be because I'm a new member, I'll try again in the near future.
Rob