Hi Eric,
I had thought about contacting Roland, but discounted the idea due to
the age/value factor. Another avenue to try though.
I wish I hadn't wasted the weekend trawling the net..........you guys
are goooooood :-)
Clive.
--- In oldsynths@yahoogroups.com, Eric Fusebox <eric_fusebox@y...>
wrote:
toward an 'Official Roland Repair Centre' who can sell you the part.
I've had to do this a couple of time and have been reasonably
successful.
manufacturer? eBay's also worth a shot as some guys are making
replacement sliders for Junos etc and they might fall into the right
range.
I had thought about contacting Roland, but discounted the idea due to
the age/value factor. Another avenue to try though.
I wish I hadn't wasted the weekend trawling the net..........you guys
are goooooood :-)
Clive.
--- In oldsynths@yahoogroups.com, Eric Fusebox <eric_fusebox@y...>
wrote:
> Hi!might not actually have the part, they should be able to point you
>
> Have you contacted Roland directly? I've found that eventhough they
toward an 'Official Roland Repair Centre' who can sell you the part.
I've had to do this a couple of time and have been reasonably
successful.
>range of that/another slider and try to find one from a new
> Also, if it's just a pot/slider, can you not measure the resistance
manufacturer? eBay's also worth a shot as some guys are making
replacement sliders for Junos etc and they might fall into the right
range.
>to
> Good Luck!
>
> Clive <analogue@i...> wrote:
>
> Hi All,
>
> I need to replace a slider in an old piece of kit and I can't seem
> find a manufacturer let alone anything else.'2MA'
>
> I hope you don't mind me asking you good people.
>
> The slider's part number is EVAL0PC15A26 and it has a rating of
> (I don't even know what that means, I'm used to Ohms!)CSQ-100
>
> The slider is used to control 'Portamento' in both the Roland
> Sequencer and their SH09 synth. It is for the former that I need it.Service.
>
> Any equivalent would be fine, it's not a control I will be using.
>
> If it's any help, there are some service docs here:
>
> http://www.synthesizerarchiv.de/circuits/roland/sh09/sh09.pdf
>
> Any help will be greatly appreciated.
>
> Thanks,
>
> Clive.
>
>
>
>
> Yahoo! Groups Sponsor
> Get unlimited calls to
>
> U.S./Canada
>
>
> ---------------------------------
> Yahoo! Groups Links
>
> To visit your group on the web, go to:
> http://groups.yahoo.com/group/oldsynths/
>
> To unsubscribe from this group, send an email to:
> oldsynths-unsubscribe@yahoogroups.com
>
> Your use of Yahoo! Groups is subject to the Yahoo! Terms of
>
>
>
> ---------------------------------
> Do you Yahoo!?
> Check out the new Yahoo! Front Page. www.yahoo.com