Off the top of my head I think that it's most likely a 2Mohms Audio (Log)
taper pot. Probably manufactured by ALPS.
mw
-----Original Message-----
From: Clive [mailto:analogue@...]
Sent: Monday, November 08, 2004 12:34 PM
To: oldsynths@yahoogroups.com
Subject: [oldsynths] Old slider pot
Hi All,
I need to replace a slider in an old piece of kit and I can't seem to
find a manufacturer let alone anything else.
I hope you don't mind me asking you good people.
The slider's part number is EVAL0PC15A26 and it has a rating of '2MA'
(I don't even know what that means, I'm used to Ohms!)
The slider is used to control 'Portamento' in both the Roland CSQ-100
Sequencer and their SH09 synth. It is for the former that I need it.
Any equivalent would be fine, it's not a control I will be using.
If it's any help, there are some service docs here:
http://www.synthesizerarchiv.de/circuits/roland/sh09/sh09.pdf
Any help will be greatly appreciated.
Thanks,
Clive.
Yahoo! Groups Links
taper pot. Probably manufactured by ALPS.
mw
-----Original Message-----
From: Clive [mailto:analogue@...]
Sent: Monday, November 08, 2004 12:34 PM
To: oldsynths@yahoogroups.com
Subject: [oldsynths] Old slider pot
Hi All,
I need to replace a slider in an old piece of kit and I can't seem to
find a manufacturer let alone anything else.
I hope you don't mind me asking you good people.
The slider's part number is EVAL0PC15A26 and it has a rating of '2MA'
(I don't even know what that means, I'm used to Ohms!)
The slider is used to control 'Portamento' in both the Roland CSQ-100
Sequencer and their SH09 synth. It is for the former that I need it.
Any equivalent would be fine, it's not a control I will be using.
If it's any help, there are some service docs here:
http://www.synthesizerarchiv.de/circuits/roland/sh09/sh09.pdf
Any help will be greatly appreciated.
Thanks,
Clive.
Yahoo! Groups Links