MOTM

Hello All -

I'm assembling a Cyndustries module into an MOTM format Schaeffer US 
panel.  The module requires a 10K pot; I've found a Bourns panel-
mount pot, but it's 9mm. I assume this is OK with a little reaming 
ala Oakley pots.  Is this the right pot?  Or are ther better 
alternatives?  Mouser part #652-3310Y-1-103.

Also, I need 3PDT switches; where can I get these in the same style 
as the NKKs? I see DPDT on Dave's site, but no 3PDT.

Finally, can I use the 5mm LEDs at Mouser (645-550-1105 for red)?  
Where do I get the cool little lenses ala MOTM for these?

Thanks mucho in advance.

Mike

Mike, on the LED...

I think the "lens" is actually part of the LED.  The snap-in mounting "flange"
I guess can be removed, but I buy the entire one-part thingy from digikey.
It's a Lumex SSI-LXH387ID, digikey #67-1155-ND (i think).

George
----- Original Message -----

From: <mmarsh@...>
To: <motm@yahoogroups.com>
Sent: Friday, February 28, 2003 2:19 PM
Subject: [motm] Pots and switches


> Hello All -
>
> I'm assembling a Cyndustries module into an MOTM format Schaeffer US
> panel.  The module requires a 10K pot; I've found a Bourns panel-
> mount pot, but it's 9mm. I assume this is OK with a little reaming
> ala Oakley pots.  Is this the right pot?  Or are ther better
> alternatives?  Mouser part #652-3310Y-1-103.
>
> Also, I need 3PDT switches; where can I get these in the same style
> as the NKKs? I see DPDT on Dave's site, but no 3PDT.
>
> Finally, can I use the 5mm LEDs at Mouser (645-550-1105 for red)?
> Where do I get the cool little lenses ala MOTM for these?
>
> Thanks mucho in advance.
>
> Mike
>
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>

At 07:19 PM 2/28/2003 +0000, Mike Marsh <mmarsh@...> wrote:
>Also, I need 3PDT switches; where can I get these in the same style
>as the NKKs? I see DPDT on Dave's site, but no 3PDT.

Mouser does not stock the switch you want.  Digikey does have it in a 0n-0n 
configuration as Digikey # 360-1114-ND.  There are other configurations 
available for the NKK 3PDT, but may be special order.


>Finally, can I use the 5mm LEDs at Mouser (645-550-1105 for red)?
>Where do I get the cool little lenses ala MOTM for these?

The Lumex LED's are one piece Fresnel lens LED's.  George is correct on 
finding them at Digikey as well with red, green and yellow available.



-dave-

http://www.hylander.com