MOTM

> From: "Paul Schreiber" <synth1@...>
>
> If I use the a dual OTA, triange-based VCO, then I can get SAW
> for a minimal
> effort.
> So, I'm thinking these lines:
>
> <<the observant will note the panel is the same as the MOTM-800!
> That's part
> of the attraction: I just change silkscreens>>
>
> COARSE
> FINE
> +/- FM
> WAVESHAPE <<between SQUARE and SAW, this is a fader pot>>
>
> jacks are
>
> 1V/Oct FM
> TRI VAR
>
> I'm thinking this will fit (barely!) on the MOTM-800 "form-factor" pcb.
> Still looking like $159 kit, $80
> less than a '300.

> Tri, Square or Saw in a 1 unit VCO, I like! Revised bmp attached.
>
> Dave
>