MOTM

Tri, Square or Saw in a 1 unit VCO, I like! Revised bmp attached.

Dave 

> From: "Paul Schreiber" <synth1@...>
> 
> If I use the a dual OTA, triange-based VCO, then I can get SAW 
> for a minimal
> effort.
> So, I'm thinking these lines:
> 
> <<the observant will note the panel is the same as the MOTM-800! 
> That's part
> of the attraction: I just change silkscreens>>
> 
> COARSE
> FINE
> +/- FM
> WAVESHAPE   <<between SQUARE and SAW, this is a fader pot>>
> 
> jacks are
> 
> 1V/Oct     FM
> TRI           VAR
> 
> I'm thinking this will fit (barely!) on the MOTM-800 "form-factor" pcb.
> Still looking like $159 kit, $80
> less than a '300.