MOTM

Huh All ? :)

I may be wrong about the MS20 (packed away in the attic), but my MS50 
sits beside me as i'm typing this :

EG1 has dual + outs as you say, but look closely :  the one on the 
left has a dash and zero volts at the bottom of the graphic (-0V) .  

The other one (right) has this dash and zero volts at the sustain 
level, this means the envelope starts somewhere negative of 0V, then 
peaks positive of 0V and then decays to 0V which is the sustain level 
of the env, at gate off, the release kicks in and the output goes 
negative again .

The negative env out is an inversion of this second out, not of the 
one that starts at 0V, which would put the whole envelope below zero .

EG2's first out, on the left is a full positive env .  The one you 
call negative (right), starts way neg, then ramps up to zero and then 
decays to negative again .  Not an inversion here, but merely a shift 
to negative .

The above may be a bit terse, but after your reactions i was 
wondering if my brain was going soft .  But rejoice, it's not :)

EG1
       /\
      /  \
     /    `-----.       -  -  -  -0V  <- This is where the 2nd out has
    /            \                       it's zero volt point .
  -\ufffd              `-  -0V <- 1st out       

My first attempt at ascimatic, hope it comes out ok, use a fixed 
pitch font, pls .

Hope this has cleared up some "huh"'s ;-)

Cheers .


Keep 'em oscillating :)


Hugo
=