MOTM

Martin,

Make sure you have a good soldering iron that has the proper tip temp,
and that your tip is not worn out. Keep it cleaned with a wet sponge.

Make sure you are touching the tip to both the pot leg and the pad at
the same time to heat them both for a couple seconds before applying
the solder.

I don't have any trouble soldering pot legs on mine.

Moe
http://www.stoogeindustries.com

--- In motm@yahoogroups.com, "marcin_grzelak" <zamarang@...> wrote:
>
> Hi,
> During my solderings works on MOTM's kits I still hit the same time-
> consuming difficulty - soldering Spestrol pots legs.
> Time and again there's one or two legs of there realy "resist" to my 
> soldering-iron.The solder "dont't want" to flow through...
> I try to bend leg a little bit in all directions, give bit more 
> temperatur - it's realy ardnous till I have a bit solder at another 
> side
> 
> Any tricks...???
> 
> Martin
>