MOTM

Thanks for all the responses.  I'm confident now that many of my modules 
will fit into the lower part of the case.

-Richard Brewster

J. Larry Hendry wrote:

>-----Original Message-----
>From: Jay [mailto:synthbaron@...]
>Sent: Monday, March 28, 2005 11:44 PM
>The DotCom has a similar cut, although it looks to be a bit shallower. But
>the one MOTM module I own (490) fits fine in the lower portion with JUST
>ENOUGH room for the jacks and wires. It looks like there's enough clearance,
>from the board pictures I've seen on your site, so that that any "official"
>MOTM module would fit.
>
>The 490 mounts on a Stooge products 3 pot short bracket.  Many MOTM products
>have a bracket that is just as deep, but is 1.625 inches taller.  Since the
>top placement is the same for both, the 1.625 inches is in the downward
>direction.  To determine if the 3 pot long bracket will fit, extend an
>imaginary line straight back from the bottom of the bracket 2.75" and see if
>that hits the bottom of the dot com cabinet.
>
>Larry
>
>
>
>
>  
>