MOTM

Tony,

I like FreqShift_ProductionNumbersAllBip.jpg as the best choice. I might 
go with an even smaller font on the smaller knobs though.

Scott
----------------------------------------------------
Tony Karavidas wrote:

> Ok here's the one with "+" on the fine shift. I made the "+" a smaller font
> size and that tightened it up a bit.
> 
> http://www.encoreelectronics.com/FS/FreqShift_ProductionNumbersAllBip.jpg
> 
> Now I'm not sure which one I like the best.
> 
> Let me know...
> Tony
> 
> 
> -----Original Message-----
> From: Tony Karavidas [mailto:tony@...] 
> Sent: Monday, December 08, 2003 4:47 PM
> To: 'groovyshaman@...'; 'motm@yahoogroups.com'
> Subject: RE: [motm] Frequency Shifter - one 'final' question
> 
> Ok, here's another option. There are numbers on all pots, but any number
> that would have been partially obscured has been removed.
> 
> http://www.encoreelectronics.com/FS/FreqShift_ProductionNumbersAll.jpg
> 
> What do you think of this? If you like this one the best so far, do you like
> the different numbers removed depending on where they are, or would you like
> the same numbers removed on all of the small pots?
> 
> Also, I had the fine shift pot with +1, +2, etc, and I really didn't like
> it. (Although it looks OK on the big knob). If you really want to see it, I
> can post that too.
> 
> Tony
>  
> 
> -----Original Message-----
> From: groovyshaman@... [mailto:groovyshaman@...]
> Sent: Monday, December 08, 2003 4:39 PM
> To: tony@...; motm@yahoogroups.com
> Subject: Re: [motm] Frequency Shifter - one 'final' question
> 
> [Although meaningless] the numbers look nice.
> Maybe just a + and - on the Fine Shift control.
> 
> George
> ----- Original Message -----
> From: "Tony Karavidas" <tony@...>
> To: "'Mark'" <yahoogroups@...>; <motm@yahoogroups.com>
> Sent: Monday, December 08, 2003 7:17 PM
> Subject: RE: [motm] Frequency Shifter - one 'final' question
> 
> 
> 
>>0 to 10 wouldn't make sense because it doesn't communicate the ability
> 
> of
> 
>>the shifter to 'invert' or shift through zero. I've updated the info 
>>on
> 
> the
> 
>>site recently to indicate it's a through zero FS.
>>
>>Yes, the Fine Shift approaches zero towards the center of its rotation.
> 
> I'll
> 
>>look into text for that knob too.
>>
>>The CV is positive only.
>>
>>Tony
>>
> 
> <snip>
> 
> 
> 
> 
> 
>  
> 
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ 
> 
>