MOTM

> ----- Original Message -----
> From: osthelder <osthelder@...>
> I just finished my MOTM-ized BZ2300, the Blacet Binary Zone.  I must say,
this is quite the toy!

I'm looking forward to building on myself.  I'm still drilling panels for
everyone else right now.

> While drilling my Stooge panel, however, I failed to notice that the hole
marker labelled "clock" was really for an LED.  I drilled it for an output
jack!

HA !!  Don't think you are the first one to make that kind of mistake.  One
of the things I do to avoid that when drilling Stooge panels is to drill all
holes the same size up to the point when each one quites getting drilled.
Once I get to 1/4", I cover the switches with tap.  Once I get done with
5/16, I cover the LEDs with tape before I move onto the 3/8.

I *did* notice that the LED used the same buffer as the intended clock
outputs, so now I have two full-width clock pulse
outputs.

Good recovery.  :)
Larry