MOTM

In a message dated 10/20/99 11:06:35 PM, jlarryh@... writes:
>>I then measured the distance between the two 
>> edges of the panels which I believe to be about 1/4". 

And I don't feel a 1/4" gap to be too bad, but if we use Larry's multi/bus 
strips then we have a "different problem" which might alleviate the problem 
of the 1/4" gap -- as it stands, I'm really leaning toward using these strips 
below each row of MOTM.

>I got a pair of rails from Musician's Friend and experienced about the
>same
>results as JWB.  Like Ken, I was hoping they would allow the modules to
>be
>flush (like the nice ones that Paul makes).  However, they did not, so
>I am
>not certain I am going to use them for that purpose.  I still have room

I agree that I'd prefer the panels to be flush in my system as well, and I 
also would agree not to use them for MOTM if Paul had some rails made for 
cabinet use -- and it would be great to see him make the strips as well so 
they were cosmetically compatible, and use the "official MOTM screw." But I 
feel that Paul has his hands full with other stuff and I don't know if 
there's enough interest to warrant distracting him. I would imagine that such 
rails would be about 24U (like Moe wants) and I'd prefer those to my 21U 
rails as well. Anybody else?

JB