MOTM

I guess I had envisioned that the interconnecting power cable would connect
in the front, with a receiver on the other end like this
http://www.wiseguysynth.com/larry/paul/back.jpg, or on some other 2U high
19" panel with other stuff on it. Tell me more about how you connect to the
back on the receiving end.

No, There are currently no plans to make this available as a Stooge panel.
I'm not saying we would not, but I the concept to make a prototype like this
was originally proposed to me by Paul.  Perhaps he plans to release the MOTM
power supply in this format.  Paul?  If not, and if there is sufficient
interest, perhaps a Stooge retro panel could be considered.  Interest
expressed to me so far in the SKB pop-up back I prototyped has been very
low. (I'm still waiting on the quote BTW).

I could whip some of these up by hand, but, I would look for a nice power
switch that fits in a round hole. Cutting the rectangular hole in this steel
was a royal pain.

The white connecting wire may not look large enough in the photos, but it
is.  It is special utility grade wire.  That is actually # 14 inside there.

Larry

----- Original Message -----
From: blip <bleep@...>

> http://www.wiseguysynth.com/larry/power.htm

so this is going to be available as a stooge panel/kit when? :) one
suggestion... it might be good to have the "additional cabinet" cable come
out the *back* of the powersupply, since it will be going into the back of
a second skb. i also like having the powercord come out the rear... very
nice work, larry...

bleep.
out.