MOTM

once again i recently heard someone state that the motm modules were too 
difficult to distiguish because of the lack of some sort of border 
around each module. has anyone ever tried or considered polishing the 
paint off the edges of your panels to make that border?

perhaps i will experement with a few diy motm panels i have (since they 
are imperfect to begin with). taking just a bit off the corner so that 
just a hairline of bare aluminum shows.

i know other methods of edging have been discussed, but i am not sure if 
we ever considered paint removal?

sounds radical, but if done with care....

...jp