Mailist to discuss all issues regarding the Digitech GSP-2101 Guitar FX Processor

also.. does your 2101 have the PPC upgrade?? it could also be that there is a processor mismatch, and you're getting the "cannon" effect from the mismatch of the SDISC processors..

--- In gsp-2101@yahoogroups.com, "newtlink" <newtlink@...> wrote:
>
> did your 2101 have the XLR fix?? on older models, there was a problem with the XLR outs using the cabinet emulators.. i think the fix was replacing a few caps on the board.. it's possible that it's one of the ones that did not have the fix..
> Jim.
> 
> --- In gsp-2101@yahoogroups.com, Todd Johnson <tj409@> wrote:
> >
> > 
> > The 2101 is clipping.  
> > However, I just (late night) received some high quality patch cables and it seemed to help.  I will have to gig with it or at least heat it up good to see if it's fixed, but the funny thing is I never had this problem before.  So I was starting to think that the unit was reaching the end of it's useful life; that capacitors were going bad or something.  I sure hope that it's not.  I hate to see this thing go, but it was an audible clip.  Very dangerous to the speakers, and expensive.
> > Todd
> > 
> > To: gsp-2101@yahoogroups.com
> > From: rish@
> > Date: Wed, 10 Feb 2010 15:37:59 -0600
> > Subject: Re: [gsp-2101] Clipping
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> > 
> >  
> > 
> > 
> > 
> >   
> > 
> > 
> >     
> >       
> >       
> >       
> > 
> > 
> > 
> > Are you clipping on the 2101 unit or your mixer/amp? 
> >  
> > I had the same issue when recording...I was using my mixer with the XLR 
> > outs on the back of the 2101 and running with the button on the back in the on + 
> > position. What worked for me was I switched the speaker compensator switch 
> > to the out position and  I went through all my effects and set all the 
> > gain and volume levels the same, now no problems. These units seem to clip real 
> > easy but I think it's due to all the effects being at different gains and volume 
> > levels.
> >  
> >  Richard
> > 
> >   ----- Original Message ----- 
> >   From: 
> >   taj7652 
> >   To: gsp-2101@yahoogroups.com 
> >   Sent: Wednesday, February 10, 2010 2:14 
> >   PM
> >   Subject: [gsp-2101] Clipping
> >   
> >   
> >   
> >   Am I the only one who has clipping on stock channels. Especially on program 
> >   change, and time related effects. I have reduced the levels to nearly nada and 
> >   still clip, clip clip.
> > 
> > 
> > 
> > 
> > 
> > 
> >     
> >      
> > 
> >     
> >     
> > 
> > 
> > 
> > 
> > 
> > 
> >    		 	   		  
> > _________________________________________________________________
> > Hotmail: Free, trusted and rich email service.
> > http://clk.atdmt.com/GBL/go/201469228/direct/01/
> >
>