Mailist to discuss all issues regarding the Digitech GSP-2101 Guitar FX Processor

Thanks for the response, but I find it hard to believe. If that is 
true it renders using the FC controller useless when switching 
between patches as you can never predict the initial settings on the 
switchover. :(

Not blaming you of course, I just wanted to be sure I articulated the 
problem clearly.

Best Regards,
  Dan 

--- In gsp-2101@yahoogroups.com, Steve Dudley <snd6760@...> wrote:
>
> From what I understand this is normal and there is nothing you can 
do about it.
> 
> dpguitarman <dpguitarman@...> 
wrote:                                  Hi Folks,
>     I am new to the group but a long time lover of the GPS2101. I 
am 
>  looking for some expertise with a problem.
>  
>  I have created two programs. One doesn't use the GSP2101FC pedal 
(call 
>  this program A) and another program does use it(call this program 
B). 
>  
>  Program B is setup to increase the gain on distortion from 3 to 11 
>  while simultaneously reducing the master volume to maintain a 
>  consistent output level. My problem is when I switch from program 
A to 
>  B.
>  
>  The pedal is up when I am in program A. I expect to switch to 
program B 
>  and have all the parameters for that pedal position maintained at 
the 
>  initial reasonable clean setting up to hot when depressing the 
pedal. 
>  Unfortunately when I switch to program B the parameters are as if 
the 
>  pedal was down (or nearly down) unless I just touch it a bit. IT 
is 
>  almost like it is not reading the initial pedal position when I 
switch 
>  to B until a touch the pedal.
>  
>  Any thoughts? Thanks Experts and have a great day! :)
>  
>  Best Regards,
>   Dan
>  
>  
>      
>                        
> 
>        
> ---------------------------------
> Luggage? GPS? Comic books? 
> Check out fitting  gifts for grads at Yahoo! Search.
>