Emax

Yes, 
I've used it for several years! sometimes start and works fine but when restart the machine appear the rare characters and fail! then need to unplug and plug the flat cable of the analog board, restart the emax without scsi zip drive and boot normal!

 
Rodolfo...


________________________________
 De: Ted Summers <djtbs1@...>
Para: emax@yahoogroups.com 
Enviado: Lunes, 21 de octubre, 2013 11:05:05
Asunto: Re: [emax] RE: EMAX 2 werid characters on LCD and no boot!
 


  
Are you sure it's a SCSI Zip drive and not a parallel?

-T




On Mon, Oct 21, 2013 at 5:30 AM, Daeron <daeron_elf@...> wrote:

 
>  
>Hi! thanks for the support!
>
>I did what you recommended, unplug  de flat cable of the analog board and cleaned it, then restart de sampler and start without problem but when connect scsi zip drive failure again! (the wrong characters and trasnposed pad lit)  i repeat the process several times and always the same!
>Is my scsi zip drive el problem?
>
>
>
> 
>Rodolfo...
>
>
>
>________________________________
> De: "sweetsynthchuck@..." <sweetsynthchuck@...>
>Para: emax@yahoogroups.com 
>Enviado: Domingo, 20 de octubre, 2013 19:55:01
>Asunto: [emax] RE: EMAX 2 werid characters on LCD and no boot!
> 
>
>
>  
>TRANSPOSE - Turned off if the analog jack port is
>detected. This will remain lit if the
>analog board is not plugged in.
>
>try reseat your analogue board connecter
>
> 
>
>
>---In emax@yahoogroups.com, <emax@yahoogroups.com> wrote:
>
>
>Hi!, just few minutes ago i try to start up my EMAX 2 and  some strange 
charaters appeared on LCD and don't boot, the light on transpose pad is 
lit! any advice! some of you lead me in the right direction here? 
thanks!!  sorry for the lo-fi video!: http://www.youtube.com/watch?v=i0PdArQsxzI&feature=youtu.be
>
>