Vintage Simmons Drums (UK) Users Group

Thanks for the replies. It sounds like I should be OK with the mk1 pads then. I'd like one day to own a SDSV, so it will be a good investment.

As to whether the lower sensitivity of my SDS1000m snare is a fault, I'm not sure - it may be a noisy sensitivity pot. I'll wait to see how it sounds with the mk1s, and maybe remove the resistor if there's a problem. Rather than remove the resistor permanently I could wire a switch to short out the resistor.



--- In Simmons_Drums@yahoogroups.com, "WT" <waveterm@...> wrote:
>
> 
> ----- Original Message ----- 
> From: "Michael Buchner" <buchnerelectronics@...>
> To: <Simmons_Drums@yahoogroups.com>
> Sent: Thursday, October 29, 2009 9:27 PM
> Subject: Re: [Simmons Drums] Mk1 pad output levels
> 
> 
> > The other aspect is, that the hard surfaces are the most responsible part 
> > for a needle-sharp click sound. As you know, the piezo is something like a 
> > microphone. Plug different pads with different surfaces directly into a 
> > mixing console and play: A rubber pad will sound different and will 
> > produce a rugged click on an SDSV. The hard surfaces produce a tight, 
> > aggressive short trigger pulse. After all drummers were complaining about 
> > their aches, simmons offered rubber overlays for the Mk1s, but they 
> > definitely changed the sound!
> > Michael
> 
> And this can be heard very clearly on various records from the early to mid 
> eighties.
> 
> WT
>