file uploaded: Milton motm 8U panel
2004-03-14 by Jeffrey Pontius
After many weeks of planning, ordering, and assembly, I finally have a Milton sequencer up and running. I've uploaded a Schaeffer front panel design to a new folder called Milton. The panel is 8U motm units wide and is designed for step led's at the top of the panel, then 4 bank boards (64 pots!), then pulse bank switches, control and output sections, and gate outputs at the bottom of the panel. Holes are for SWitchcraft 112 sockets, pot holes are for the pots recommended in Milton's parts list (these are a tight fit with the panel's thickness), pushbutton holes are for E-Switch pushbuttons, switch holes are for Mountain switches, and led holes are for some cute chrome dome type leds (from Lumex, IIRC). One word of caution: Because of space constraints, the switches are located *very close* to the lowest bank board (lowest row of pots). So if you decide to use this panel, please check spacing with your components (as well as for anything else - standard procedure). Comments appreciated. I think Peter will post some photos on his site or in the Milton yahoo groups. Jeff