Yahoo Groups archive
Thread
2009-11-23 by CV-Gate
Hello list, I just built an Ian Fritz All-In Envelope Generator kit recently bought in the Bridechamber. It seems to be working OK but the led doesn't blink. There is no led polarity indication on the PCB but I tried both ways. I don't know if it needs any jumper. As you can see my electronics knowledge is not very extensive :-) Please, any of you could provide any help? Thanks in advance. Miguel.
2009-11-24 by Scott Deyo
Hello list,
I just built an Ian Fritz All-In Envelope Generator kit recently bought in the Bridechamber. It seems to be working OK but the led doesn't blink.
There is no led polarity indication on the PCB but I tried both ways. I don't know if it needs any jumper.
As you can see my electronics knowledge is not very extensive :-)
Please, any of you could provide any help?
Thanks in advance.
Miguel.
2009-11-24 by Miguel Mendoza
----- Original Message -----From: Scott DeyoSent: Tuesday, November 24, 2009 5:38 AMSubject: Re: [ModularSynthPanels] Ian Fritz The All-In Envelope GeneratorAnd the Pulse section is working? I don't think it should if the LED doesn't...
The flat part should be towards the bottom of the board. The circle is flat on that side, but it's not so obvious.Do you have any other LEDs around? I could send another.
Scott DeyoThe BridechamberJealous Edison Record Kompany
On Nov 23, 2009, at 4:45 PM, CV-Gate wrote:
Hello list,
I just built an Ian Fritz All-In Envelope Generator kit recently bought in the Bridechamber. It seems to be working OK but the led doesn't blink.
There is no led polarity indication on the PCB but I tried both ways. I don't know if it needs any jumper.
As you can see my electronics knowledge is not very extensive :-)
Please, any of you could provide any help?
Thanks in advance.
Miguel.
2009-11-24 by Scott Deyo
Thanks Scott. The led is working. I though that it should work using the gate/trigger input but now I don't think so... It works only on mono input, right?Regards.Miguel.----- Original Message -----From: Scott DeyoSent: Tuesday, November 24, 2009 5:38 AMSubject: Re: [ModularSynthPanels] Ian Fritz The All-In Envelope GeneratorAnd the Pulse section is working? I don't think it should if the LED doesn't...
The flat part should be towards the bottom of the board. The circle is flat on that side, but it's not so obvious.Do you have any other LEDs around? I could send another.Scott DeyoThe BridechamberJealous Edison Record KompanyOn Nov 23, 2009, at 4:45 PM, CV-Gate wrote:Hello list,
I just built an Ian Fritz All-In Envelope Generator kit recently bought in the Bridechamber. It seems to be working OK but the led doesn't blink.
There is no led polarity indication on the PCB but I tried both ways. I don't know if it needs any jumper.
As you can see my electronics knowledge is not very extensive :-)
Please, any of you could provide any help?
Thanks in advance.
Miguel.