hey guys - sorry i've been out with an ear infection in my good ear! let me answer
some questions - even though i'm deaf now i just messed around with the sn-voice.
i take back anything i said about being 2U, it should def be 3U
i will wire up your vactrol cv resistor board tonight/tomorrow scott and try it on the filter
i think it would be really nice addition - sending cv to the pitch source is great fun
and the filter is really sweet and its there so why not
on the logic inputs i didnt mean sweep in the synth sence - but with a lfo you can switch
between one of two (or three w/ another lfo) of the chips modes - which are fun! but not
as important as the other features of the snvoice
you should have your snvoice soon
dave
ps i got one of the supercontroler boards as well and would be down for a panel for it too!
On Oct 14, 2007, at 7:20 PM, Scott Deyo wrote:
yo davei'm not quite cipherin' the mixer input trick. how do you sweep them w/ an lfo? i see three logic pins.Scott DeyoThe Bridechamberwww.bridechamber.comOn Oct 11, 2007, at 10:40 PM, david wright wrote:hey everyone - i have an snvoice on a a 4U panel using big switches and rotaries.i would prefer it was 2U (3u at max) - i find the rotaries for pulse width couldbe replaced with a spst between LFO/ENV modulation, the rotary for thelfo speed could be a center off mini switch for three speeds, i could live withoutthe fine tune control, i could deal with less CV inputs and attuns, i like scott's modfor changing the env response, but could just do it with a trimpot. i really enjoyto have the mixer inputs to an input jack - its allot of fun to send an lfo into themto sweep from noise/vco/lfo etc. look there its almost 2U - but still a few potsn jacks too much - any other opinions? i could deal without the pulse width inputsbecause the lfo/env do such a good job allreadywhat a great module -daveOn Oct 11, 2007, at 12:57 PM, Scott Deyo wrote:I'll try to get to this one, but it will be a little while.What options do people want to see in it?Scott DeyoThe Bridechamberwww.bridechamber.comOn Oct 11, 2007, at 12:02 PM, gino wong wrote:I just ordered a pcb for an SN 76477 module. Most of us have messedaround with these things for years. So Tom Henry tricked it out andanother fella came up with a pcb (run of 50) uses a cd4046 PLL.I want to do it as a 2-3u voice panel.Do I have any brethren ?bestgino
dave wrightwww.notbreathing.com
dave wright
www.notbreathing.com