Modular Synth Panels

Time to send this panel to the pros :). I d rather spend my time on unique circuitry or software!

Thx for walking me thru this Julian!


------------------------------
On Fri, Apr 18, 2014 6:53 PM CDT port23.co.uk@... wrote:

>Its not easy to DIY, but its possible.  Of course, if you have a mill... but im assuming you dont, so - 
>
>Print out the design on paper, to scale.
>Choose a drill bit smaller than the dia of the cut-out
>Draw dots on your paper, along the centerline of the cut-out, spaced apart so as the finished drill holes will virtually overlap. (but, if they do overlap, i suspect you will have issues drilling them...)
>Overlay the paper ontop of the panel.
>Center mark where your dots are
>Drill
>Then drill again, tilting the drill.  This is where itll all get a bit dicey.  Tilting the drill will break one hole into the next.
>Finish by filing clean.
>
>
>You can do this kind of stuff with a jigsaw also, but its very very likely that you will damage the surface.around where you are trying to cut.
>
>Good luck!
>
>Julian