thanks for your help...I guess I will stick with Schaeffer...
From: roglok <roglok@...>
To: ModularSynthPanels@yahoogroups.com
Sent: Friday, 30 March 2012, 7:40
Subject: [ModularSynthPanels] Re: getting started
To: ModularSynthPanels@yahoogroups.com
Sent: Friday, 30 March 2012, 7:40
Subject: [ModularSynthPanels] Re: getting started
judging from the examples on that page it's probably only capable of engraving and drilling soft materials like pvc/wood/epoxy...
--- In ModularSynthPanels@yahoogroups.com, Dean Luca <lucadean@...> wrote:
>
> is this good for doing your own modular panels (holes and engraving)?
>
> http://www.ebay.co.uk/itm/CNC-3020T-DESKTOP-ROUTER-ENGRAVER-ENGRAVING-DRILLING-MILLING-MACHINE-NEW-q9-/180832846184?_trksid=p3284.m263&_trkparms=algo%3DSIC%26its%3DI%26itu%3DUCI%252BIA%252BUA%252BFICS%252BUFI%26otn%3D21%26pmod%3D220917809781%26ps%3D54
>
>
>
>
> ________________________________
> From: Doug <dougslocum@...>
> To: ModularSynthPanels@yahoogroups.com
> Sent: Friday, 30 March 2012, 10:42
> Subject: [ModularSynthPanels] Re: getting started
>
>
> Â
> Check out cnczone.com Lots of helpful folks.
>
> --- In ModularSynthPanels@yahoogroups.com, gino wong <ginowong@> wrote:
> >
> > I am actually thinking of getting a small cnc machine do both panels and
> > green circuit boards. I would share it as I don't need the full capacity
> > of the thing. I was thinking of drafting the Ills , expert panel designers
> > they are but when costing out a trapezoid via a while back an fpd panel
> > costed out to over $200. One tenth the cost od some cnc rigs.
> >
>