Modular Synth Panels

is this good for doing your own modular panels (holes and engraving)?

http://www.ebay.co.uk/itm/CNC-3020T-DESKTOP-ROUTER-ENGRAVER-ENGRAVING-DRILLING-MILLING-MACHINE-NEW-q9-/180832846184?_trksid=p3284.m263&_trkparms=algo%3DSIC%26its%3DI%26itu%3DUCI%252BIA%252BUA%252BFICS%252BUFI%26otn%3D21%26pmod%3D220917809781%26ps%3D54




________________________________
 From: Doug <dougslocum@...>
To: ModularSynthPanels@yahoogroups.com 
Sent: Friday, 30 March 2012, 10:42
Subject: [ModularSynthPanels] Re: getting started
 

  
Check out cnczone.com  Lots of helpful folks.

--- In ModularSynthPanels@yahoogroups.com, gino wong <ginowong@...> wrote:
>
> I am actually thinking of getting a small cnc machine do both panels and
> green circuit boards.  I would share it as I don't need the full capacity
> of the thing.  I was thinking of drafting the Ills , expert panel designers
> they are but when costing out a trapezoid via a while back an fpd panel
> costed out to over $200.  One tenth the cost od some cnc rigs.
>