Modular Synth Panels

Well, not to add anything constructive or helpful, I would prefer a narrower panel with verniers but a big wide one with wave shapers is cool too. Regardless of width I'm in for two (in 5U of course) :) 

--- In ModularSynthPanels@yahoogroups.com, Scott Deyo <contact@...> wrote:
>
> If you'd be willing to do the spec-work, that would help it happen.
> 
> Scott Deyo
> contact@...
> The Bridechamber
> www.bridechamber.com
> Jealous Edison Record Kompany
> www.jealousedison.com
> 
> 
> 
> 
> On May 17, 2010, at 12:55 PM, wjhall11 wrote:
> 
> > When Will and I were looking into the Verniers, we saw that  
> > different ones have different anti-rotation hole locations. But  
> > Scott could choose a couple of the most common dials and drill holes  
> > for them both as the anti-turning holes will be behind the dials and  
> > not seen. Just a thought. Oh - and I'd be happy to do the footwork  
> > and gather different dial specs. Bill
> >
> > --- In ModularSynthPanels@yahoogroups.com, "Todd" <babysealclub@>  
> > wrote:
> > >
> > > With all due respect, I disagree. If all three holes are not  
> > perfect the verniers will not line up right. A small difference on  
> > the anti rotation hole equals a big difference with knob allignment.  
> > I can't imagine the additional three holes adding much to the cost.
> > >
> > > -TF
> > >
> > > --- In ModularSynthPanels@yahoogroups.com, "adaaxs" <ginowong@>  
> > wrote:
> > > >
> > > > It would probably be easier just to mark where you would drill a  
> > hole for anti rotation ala EMS. Drill it if you need it and save the  
> > expense, as it is this panel is going to be very pricey.
> > > >
> > > > --- In ModularSynthPanels@yahoogroups.com, "Todd"  
> > <babysealclub@> wrote:
> > > > >
> > > > > Is there a consensus on the big multi turn knobs vs a coarse /  
> > fine arrangement? I recently built a LVCO in Euro for bbow73  
> > (picture at Muff's). We used the big multi turn gym locker knobs.  
> > They're cool,but they're not cheap.
> > > > >
> > > > > Scott - If you go with a big knob setup PLEASE ADD THE SMALL  
> > ANTI-ROTATION HOLE.
> > > > >
> > > > > -TF
> > > > >
> > > > > P.S. Be sure to add the small antirotation hole. It needs to  
> > be perfect. I'm handy with my drill press, but it really needs to be  
> > perfect. I think I spent half a day getting those things lined up.
> > > > >
> > > > > --- In ModularSynthPanels@yahoogroups.com, Eric Frampton  
> > <eric@> wrote:
> > > > > >
> > > > > > Was a consensus ever reached about what this panel should  
> > look like?
> > > > > >
> > > > > > Is there an ETA?
> > > > > >
> > > > > > Thanks,
> > > > > > Eric
> > > > > >
> > > > >
> > > >
> > >
> >
> >
> >
>