Modular Synth Panels

When Will and I were looking into the Verniers, we saw that different ones have different anti-rotation hole locations.  But Scott could choose a couple of the most common dials and drill holes for them both as the anti-turning holes will be behind the dials and not seen.  Just a thought.  Oh - and I'd be happy to do the footwork and gather different dial specs.  Bill


--- In ModularSynthPanels@yahoogroups.com, "Todd" <babysealclub@...> wrote:
>
> With all due respect, I disagree.  If all three holes are not perfect the verniers will not line up right.  A small difference on the anti rotation hole equals a big difference with knob allignment.  I can't imagine the additional three holes adding much to the cost.  
> 
> -TF    
> 
> --- In ModularSynthPanels@yahoogroups.com, "adaaxs" <ginowong@> wrote:
> >
> > It would probably be easier just to mark where you would drill a hole for anti rotation ala EMS. Drill it if you need it and save the expense, as it is this panel is going to be very pricey.
> > 
> > --- In ModularSynthPanels@yahoogroups.com, "Todd" <babysealclub@> wrote:
> > >
> > > Is there a consensus on the big multi turn knobs vs a coarse / fine arrangement?  I recently built a LVCO in Euro for bbow73 (picture at Muff's).  We used the big multi turn gym locker knobs.  They're cool,but they're not cheap. 
> > > 
> > > Scott - If you go with a big knob setup PLEASE ADD THE SMALL ANTI-ROTATION HOLE.  
> > > 
> > > -TF
> > > 
> > > P.S. Be sure to add the small antirotation hole.  It needs to be perfect.  I'm handy with my drill press, but it really needs to be perfect.  I think I spent half a day getting those things lined up.
> > > 
> > > --- In ModularSynthPanels@yahoogroups.com, Eric Frampton <eric@> wrote:
> > > >
> > > > Was a consensus ever reached about what this panel should look like?
> > > > 
> > > > Is there an ETA?
> > > > 
> > > > Thanks,
> > > > Eric
> > > >
> > >
> >
>