Middle lug via 200k resistor (haven't tested this yet, but should be a good value) to two places:
CVSN of Filter B
Junction of Junction of 100k and 2k2 resistors that go to pin 2 of Filter A CV inputs op-amp
Right lug to ground
So, the effect should be, putting 5V in, with pot turned all the way up, Filter A should go down around 2V5-worth of frequency, and Filter B should go up an equal amount.
Scott Deyo
The Bridechamber
Jealous Edison Record Kompany
On Feb 11, 2010, at 5:14 PM, joshdaigleusa wrote:
How is the spread CV on the bridechamber panel for the CGS CMOS VCF pansl wired up? I don't see anything on the CGS site and tried to do some searching here but couldn't turn up anything.
Thanks!