I was surprised by my most recent panel that the engravings were not filled. I've read a lot about people who go with no in-filling and it does look pretty nice.
I checked my design files and every legend was in-filled with white. I emailed FrontPanelExress and they called me back. On the panel properties there is a check box that is required to enable in-filling the engravings. It must be checked before any of the legend properties will take affect.
I didn't know that. They offered to in-fill them for me but I'm going to give it a go with an oil-paint stick. If it doesn't work I can clean it off and send it back for them to do it.
Thought I'd pass this tip along. It may be important if you start with someone else's panel design.
Dave
I checked my design files and every legend was in-filled with white. I emailed FrontPanelExress and they called me back. On the panel properties there is a check box that is required to enable in-filling the engravings. It must be checked before any of the legend properties will take affect.
I didn't know that. They offered to in-fill them for me but I'm going to give it a go with an oil-paint stick. If it doesn't work I can clean it off and send it back for them to do it.
Thought I'd pass this tip along. It may be important if you start with someone else's panel design.
Dave