Modular Synth Panels

I don't think so, maybe. The 2" x 6" board seems to have more stuff.

Pots: Rise, Fall, Rise CV, Fall CV, Rise Rate, Fall Rate, Processor  
(normalled to Both CV)
Jacks: Rise CV, Fall CV, Both CV, Input, 1v/ oct, Proc In, Proc Out,  
Trigger, Output, End Out
Switches: Rise Exp, Fall Exp, Cycle
LED

I still ended up leaving off the AC Out and Bipolar Out. Maybe an AC/  
DC Out switch would fit. It's already pretty cramped, so what's one  
more switch?
: )

Scott Deyo
contact@...
The Bridechamber
www.bridechamber.com
Jealous Edison Record Kompany
www.jealousedison.com




On Oct 4, 2009, at 8:00 PM, sduck409 wrote:

> Hopefully you just remembered incorrectly - just 4 pots. 10 jacks, 3  
> switches (just one if you use switching pots), and an led.
>
> --- In ModularSynthPanels@yahoogroups.com, Scott Deyo <contact@...>  
> wrote:
> >
> > I am. I have the layout done and will upload it this weekend, I  
> hope.
> > IIRC it has 10 jacks, 7 pots, 3 switches.
> >
> > Scott Deyo
> > contact@...
> > The Bridechamber
> > www.bridechamber.com
> > Jealous Edison Record Kompany
> > www.jealousedison.com
> >
> >
> >
> >
> > On Oct 3, 2009, at 8:33 AM, Richard Brewster wrote:
> >
> > > Is Bridechamber doing a MOTM panel for this?
> > >
> > > Richard Brewster
> > > http://pugix.com
> > >
> > > Ross Stapf wrote:
> > > >
> > > >
> > > > I've built one. I have another half finished. The only problem  
> is
> > > > the led's.
> > > > http://www.electro-music.com/forum/topic-26503-25.html Look at  
> this
> > > > thread, page 2 about half way down is when the MOTM version is
> > > > discussed. There is a part list for the euro version on page 1
> > > that I
> > > > used and it was right for the most part.
> > > >
> > > > It is well labeled and was pretty easy to build. Again see the
> > > > instructions Andrew F posted to fix this. Other folks mention a
> > > > problem with the euro boards. I did not have this issue. The  
> only
> > > > problem I had was with the LED's and the fix Andrew F gave works
> > > just
> > > > fine.
> > > >
> > > > This was the first project I did without step by step
> > > instructions. I
> > > > had been doing diy for less than a year when I finished it. I  
> used
> > > > Sduck's panel layout.
> > > >
> > > > Ross
> > > >
> > > >
> > >
> > >
> > >
> >
>
>
>