Modular Synth Panels

Wow, tough call!  If I were doing it for myself, I would do one of two
things. If I went with the horizontal version I'd go off the standard MOTM
grid and move filter A's jacks up into the section with the controls and
move section B down a bit etc. But if I really was going to build this I
would do the vertical design but in 2U instead of 3U by combining the
Frequency and Frequency CV controls into a dual concentric pot (if
possible), moving the Mode switches down to where the Frequency CV controls
were and then move the Input jacks up and the Output jacks over underneath
the Input jacks. 

 

John L  Rice

 

From: ModularSynthPanels@yahoogroups.com
[mailto:ModularSynthPanels@yahoogroups.com] 
Sent: Saturday, August 22, 2009 1:16 PM
To: ModularSynthPanels@yahoogroups.com
Subject: [ModularSynthPanels] New poll for ModularSynthPanels

 

  


Enter your vote today! A new poll has been created for the 
ModularSynthPanels group:

For an MOTM-format CGS Dual CMOS Filter, do you prefer the vertical or
horizontal layout?
They're in the Proposed Bridechamber Designs folder. 

o Vertical 
o Horizontal 

To vote, please visit the following web page:
http://groups.yahoo.com/group/ModularSynthPanels/surveys?id=2220793 

Note: Please do not reply to this message. Poll votes are 
not collected via email. To vote, you must go to the Yahoo! Groups 
web site listed above.

Thanks!