I think it's brilliant. Until I saw this, I wasn't sure about the dials, but now I am 100% sold. This panel design has me very excited to start on these boards. So much in the solder queue... but I think these have to jump the line.
cheers,
eric f
cheers,
eric f
--- On Fri, 5/29/09, Jeff Laity <synthetic@...> wrote:
From: Jeff Laity <synthetic@...>
Subject: Re: [ModularSynthPanels] Living VCO
To: ModularSynthPanels@yahoogroups.com
Date: Friday, May 29, 2009, 12:29 AMNice design. I'd prefer a panel without the Vernier dial, though. I like the mixed big and small knobs, and that the jacks are MOTM standard spacing. (And the font ;) )
Also, do the trims have to be on the front panel? Why not just put them on the board?On May 26, 2009, at 7:18 PM, Scott Deyo wrote:The 'ills have some designs they've been working on:
http://dragonflyall ey.com/construct ionJHLivingVCO. htm
Scott Deyo
The Bridechamber
contact@bridechambe r.com
http://www.bridecha mber.com
Jealous Edison Record Kompany
http://www.jealouse dison.com
On May 25, 2009, at 11:48 AM, adaaxs wrote:
I know this is down the road (wish it wasn't) but are there any ideas for JH living vco panels ? is it going to be one w controller and add ons or full three w controller like on a Moog ? I have been dropping threes of every type I have ever done except lfos.
For me it lvco is an easy build, couldn't resist starting on one. I found that the smaller smd bypass caps (1205 ?) are easier to attach to the pcb, much neater and I don't melt them.