I believe you can combine the interpolating scanner and vibrato into
one as Dave Brown has done:
http://modularsynthesis.com/jhaible/scanner/jhscanner.htm
Then you don't have to provide two panels for this one PCB. I was
going to assemble mine in a similar way, but probably without the LED
inside the pot shaft. I figured this would probably require a 3U
panel; Dave's is a bit tight at 2U, imho.
one as Dave Brown has done:
http://modularsynthesis.com/jhaible/scanner/jhscanner.htm
Then you don't have to provide two panels for this one PCB. I was
going to assemble mine in a similar way, but probably without the LED
inside the pot shaft. I figured this would probably require a 3U
panel; Dave's is a bit tight at 2U, imho.
>
> oops -- vibrato : )
> uses same board as interp. scanner